12 Volt 150psi compressor and 9 Litre 200 psi Air tank Universal Full System for Nissan/Holden/Mitsubishi/Toyota Hilux etc
As low as $670.00
A universal complete air system with one 12 Volt 150psi 160lpm compressor, 9 Litre 200psi tank and other accessories included
In stock
SKU
AOBFS949
12 Volt 150 Psi 160LPM 9 Litre Complete Air System
This system comes with all the following items:
- ''Air On Boards'' AOBCM900 compressor
- 9 litre tank rated at 200psi
- 70 Psi on / 100 Psi off heavy duty pressure switch
- Drain valve
- Safety valve
- Mounting Bolts
- Inline discharge check valve
- Rubber bush compressor mount
- Full wiring kit
- All hoses and accessories required.
- 3 meter 9 x 12mm air line.
- Instruction Manual
It can be used to fill tires, run Air jacks, pump up mattresses and inflatable boats in good time, run your ARB air lockers, air bags and train horns, even run small Pneumatic air tools all from your 4WD or car.
Whilst this sort of compact 12 volt system will not give you the amount of air that our ''Air on Board'' engine belt driven system will, it still comes with an impressive set of figures:
- Max Current Draw Input Volt: DC 12V - 13.8V
- Duty cycle: 20MIN @ 24°C Ambient
- Max working pressure: 150 psi
- Amp draw: 45 Amps
- Max Flow Rate: 160L/min
- Operating Temp: -55°C-60°C
- Compressor Net Weight: 8.7kg
- Fill a 31/10.5/R15 Tyre from 0 psi to 30 psi in a 1 minute 30 seconds
AOBCM900 COMPRESSOR
At the heart of this system is ''Air ON Boards'' very impressive 12 Volt compressor part number AOBCM900
It has a full Steel body (325mm x 225mm x 150mm) and out preforms all 12 volt compressors of its type on the market today. With a maximum output of 150 Psi and a duty cycle of 20min at 24 deg C and 40 Psi it will provide you with enough air for all your needs.
AOBTK209
This is the medium tank in our range and has been designed to fit most vehicles. The tank comes including a bottom a drain tap that is used to empty any condensate that is collected during the running cycle along with all the blanking plugs required to fit the full system.
AOBTK209 Dimensions
505mm x 185mm x 170mm.
Ensure you have the room to fit this tank.
AOBMB001 MANIFOLD SET
Included with this system are all the air accessories needed for your system in this neat manifold block. Makes for easy installation.
WIRING KIT
Everything you need to install and wire this compressor is include in the sale price. Don't get court by buying 12 volt compressors with out the CORRECT wiring kit. By buying it all included you can be assured that you will receive the correct size fuses, relays, switches and wire.
- 100 mm black earth cable.
- 12 volt 30 amp relay.
- 3mtr 4mm power cable.
- 3mtr 3mm power cable.
- low amp fuse holder.
- High amp fuse holder.
- 12 volt toggle switch.
- All connectors, pre-wired ready to install .
RUBBER MOUNT
The compressor is supplied with rubber vibration pads to protect the compressor from excessive vibration.The compressor is supplied with rubber vibration pads to protect the compressor from excessive vibration
It is not recommended to mount any 12 volt compressor up side down. Whilst it will still run mounted in this position, the problem is caused by the heat generated by the compressor not escaping correctly and radiating back through the compressor body into the windings. This causing damage to the motor and premature failure of the compressor.
| Comp Max Pressure | 150Psi |
|---|---|
| Horn | Without Horn |
| Tank | 9 Litre |
Write Your Own Review