Direct Mitsubishi replacement M101G AIR COMP ON-OFF Push Button Switch with dual LED lights in GREEN

Push Switch AIR COMP M101G fits Mitsubishi Pajero, Challenger, Triton ML MN, Endeavor, Eclipse, ASX with LED in green

Direct Mitsubishi replacement M101R AIR COMP ON-OFF Push Button Switch with dual LED lights in RED

Push Switch AIR COMP M101R fits Mitsubishi Pajero, Challenger, Triton ML MN, Endeavor, Eclipse, ASX with LED in red

Push Switch AIR COMP M101O fits Mitsubishi Pajero, Challenger, Triton ML MN, Endeavor, Eclipse, ASX with LED in amber

12V 3A Mitsubishi Push Switch LED amber On-Off
$25.50
Availability: In stock
SKU
SWM101O

12V 3A ON - OFF Mitsubishi PUSH Switch
Twin L.E.D Lights

This Switch Suits the following Mitsubishi models ONLY:

ASX 2010 - Current
Challenger 2009 - 2015
Eclipse 2005 - 2012
Endeavor 2004 - 2008 2010 - 2011
Galant 2004 - 2011
Pajero 2002 - Current
Triton ML 2009 - 2015
Triton MN 2009 - 2015

Any Mitsubishi vehicle using the existing ASC switch will be able to fit this new switch without any modification to the dash.

 


 

This high quality 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 35 mm x 18 mm and length of 60 mm. Any Mitsubishi vehicle using the existing ASC switch shown above will be able to fit this new switch without any modification to the dash.

This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

  • Single Pole Single Throw ON - OFF PUSH switch
  • Black hard surface.
  • Laser etched Legend
  • Single upper L.E.D light in AMBER.
  • Single lower L.E.D light in AMBER.
  • Lower light is ON when the switch is pressed IN.
  • Upper light can be wired to separate dash light circuit.
  • Rated at 3Amp 12V.
  • Wiring diagram supplied with switch.

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.

 

Rear picture of AOBSWM100 series Mitsubishi Push Button Switch

Mitsubishi Switches

Rear picture showing terminals and wiring harness supplied with switch.Wiring diagram will be supplied with switch purchase.

Light Illumination effect of AOBSWM100 series Mitsubishi Push Button Switch with dual LED LIGHTS in AMBER

Mitsubishi Switches Illumination

When switch is turned on the bottom light illuminates.

The top light (image) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the LED LIGHT BAR logo)

More Information
Operation_Type ON-OFF
Switch Logo AIR COMP 01
Color AMBER AMBER
Material Plastic
Electric_ Rating 12V 3A
Lights Dual backlit LED lights. Lower light is ON when the switch is pressed UP. Upper light can be wired to separate dash light circuit.
Write Your Own Review
You're reviewing:Push Switch AIR COMP M101O fits Mitsubishi Pajero, Challenger, Triton ML MN, Endeavor, Eclipse, ASX with LED in amber
Your Rating