Direct Toyota replacement 878G 2WD LOW RANGE ON-OFF Push Button Switch with dual LED lights in GREEN

Push Switch 2WD LOW RANGE 878G fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in green

Direct Toyota replacement 878O 2WD LOW RANGE ON-OFF Push Button Switch with dual LED lights in AMBER

Push Switch 2WD LOW RANGE 878O fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in amber

Push Switch 2WD LOW RANGE 878GR fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in green red

12V 3A Laser etched ON-OFF Toyota OEM Replacement Push Switch 878GR with dual LED lights in green red and 2WD LOW RANGE legend
$18.60
Availability: In stock
SKU
SW878GR

12 Volt 3amp ON-OFF TOYOTA PUSH Switch
Twin L.E.D Lights

This Switch Suits the following models ONLY:

4Runner
2003 - 2009
FJ Cruiser
2007 - 2018
Fortuner
2005 - 2014
HiAce
2005 - 2013
Hilux KUN26R, GGN15R, GGN25R
2005 - Early 2015
Kluger
2001 - 2007
Landcruiser 76 / 78 / 79 Series
Plastic Dash
Landcruiser 100 Series
1998 - 2007
Prado 120 Series
2003 - 2009
Tundra (Centre console if exists)
2005 - 2006

This Switch will not fit the new Hilux GUN series

Please check the hole size before purchase

 


 

This 12 volt push switch from AOB is a single pole single throw ON-OFF switch designed to operate your 12 volt accessories. It has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.

This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

  • Single Pole Single Throw ON-OFF PUSH switch
  • Black hard surface
  • Laser etched Legend
  • Single upper L.E.D light in GREEN
  • Single lower L.E.D light in RED
  • Upper light is ON when the switch is pressed IN
  • Lower light can be wired to separate dash light circuit
  • Rated at 3Amp 12V
  • Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's.Therefore in ALL cases the accessory MUST be wired through a fused relay.

 

Example of Dash Panel from 2010 Toyota with AOBSW800 series Push Button Switches with dual LED LIGHTS in GREEN RED

Example of Dash Panel with AOBSW800 series Push Switches

Panel shown from 2010 Toyota. This Panel is mounted on the left side of the steering wheel.

Rear picture of AOBSW800 series Toyota Push Button Switch

AOBSW800 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

Light Illumination effect of AOBSW800 series Toyota Push Button Switch with dual LED LIGHTS in GREEN RED

AOBSW800 series Illumination

When switch is turned on the top light (picture 1) illuminates.

The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the LED LIGHT BAR logo)

More Information
Single / Dual Single Push
Face_Size 39mm x 21mm
Switch Logo 2WD LOW RANGE 78
Lights Dual backlit LED lights. Upper light is ON when the switch is pressed IN. Lower light can be wired to separate dash light circuit.
Switch_Layout VERTICAL
Electric_ Rating 12V 3A
Operation_Type ON-OFF
Color GREEN RED
Material Plastic
Extra Info For Toyota Prado 120, HiAce, Landcruiser 76 78 79 100, Kluger, Hilux, FJ Cruiser, Fortuner, 4Runner, Tundra
Write Your Own Review
You're reviewing:Push Switch 2WD LOW RANGE 878GR fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in green red
Your Rating