Push Switch AIR HORN 8B54NG fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in light green MOMENTARY

12 Volt 3amp MOMENTARY TOYOTA PUSH Switch
NEW LIGHT GREEN COLOUR

This Switch Suits the following models ONLY:

This Switch will not fit the new Hilux GUN series

Please check the hole size before purchase

This 12 volt push switch from AOB is a single pole single throw MOMENTARY switch designed to operate your 12 volt accessories. It has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.

This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

• Single Pole Single Throw MOMENTARY PUSH switch
• Black hard surface
• Laser etched Legend
• Single upper L.E.D light in BLUE
• Single lower L.E.D light in LIGHT GREEN
• Upper light is ON when the switch is pressed IN
• Lower light can be wired to separate dash light circuit
• Rated at 3Amp 12V
• Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's.Therefore in ALL cases the accessory MUST be wired through a fused relay.

Example of Dash Panel with AOBSW800 series Push Switches

Panel shown from 2010 Toyota. This Panel is mounted on the left side of the steering wheel.

AOBSW800 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

AOBSW800 series Illumination

When switch is turned on the top light (picture 1) illuminates.

The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the DRIVING LIGHTS logo)