This Switch Suits the following models ONLY:
This Switch will not fit the new Hilux GUN series
Please check the hole size before purchase
This 12 volt push switch from AOB is a single pole single throw ON-OFF switch designed to operate your 12 volt accessories. It has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's.Therefore in ALL cases the accessory MUST be wired through a fused relay.
Example of Dash Panel with AOBSW800 series Push Switches
Panel shown from 2010 Hilux SR5. This Panel is mounted on the right side of the steering wheel.
AOBSW800 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSW800 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the AIR COMP logo)
Single / Dual | Single Push |
---|---|
Face_Size | 39mm x 21mm |
Switch Logo | AIR HORN B54 |
Lights | Dual backlit LED lights. Upper light is ON when the switch is pressed IN. Lower light can be wired to separate dash light circuit. |
Switch_Layout | VERTICAL |
Electric_ Rating | 12V 3A |
Operation_Type | ON-OFF |
Color | LIGHT GREEN |
Material | Plastic |
Extra Info | For Toyota Prado 120, HiAce, Landcruiser 76 78 79 100, Kluger, Hilux, FJ Cruiser, Tundra |