Air Ride Suspension Valve Block Solenoid Valve 2 Port Direct Action + Air Pressure Gauge Dual Digital Display

Air Ride Suspension Valve Block

100% Brand New and High Quality
For use with electronic level controller or any other brand of controller or switches.
Prewired and numbered port to reduce installation time.
1/4" NPT ports for more flexibility of installation.
High Pressure Rated for operation up to 200 psi.
Dual Inlet & Exhaust ports for maximum flow (Plug extra inlet if not required).
Compact Layout for minimal space usage.
Anodized Aluminum Manifold to prevent corrosion.
100% Weather Resistant for harsh under vehicle environments.
No tee fittings needed to run analog or digital gauges.
No tee fittings needed between inflate and deflate valve.
Using less fittings means quickest response times and fewer places to leak.
Controls 2 bags independently.

Air Pressure Gauge Dual Digital Display

100% Brand New and High Quality
Easy to use and install, seamlessly integrates with the vehicle interior
52mm dual air pressure gauge with Blue LED readings of pressure, rapid and accurate response, easy to read.
High contrast PMVA LCD screen and high quality sensors with heat-resistant.
The sensors are full electronic, so there is no chance of a leak occurring in tubing going to inside your cab, as there is none! Only wiring.
Try to avoid having the sensors located where water can accumulate, best place is the top of any air reservoir.

Air Ride Suspension Valve Block

Item Type: Manifold valve block
Material: alloy
Color: As pictures shown
Total Power: 12.6W
Working Voltage: 12V
Minimum Open Voltage: 8V
Grade of Coil Insulation: H/180 C
Ambient Temperature: -40℃ - +85℃
Test of Fatigue Life: 10 million times
Vibration Resistance: 10g/500HZ
Working Pressure: 0-200 psi
IN PORT: tank air pressure in port 1/4 NPT x 2 (if only 1 required blank the 2nd)
OUT PORT: EXHAUST PORT OUT 1/4 NPT x 2 (if only 1 required blank the 2nd)
Gauge Pressure Sensor Ports: 2 x 1/8 NPT
Airbag Ports: 2 x 1/4 NPT

Air Pressure Gauge Dual Digital Display

Voltage: DC12V-24V
Diameter Size: 2" (52mm)
Material: Aluminum Alloy & Plastic
Current: IGN Maximum 0.3A ILM 0.3A
Color: Black
Light Color: Blue
Unit: PSI
Display range: 0-200 psi
Electronic Sensors: 1/8NPT
Sensor three core wire:
Red-sensor 5V input
Black-sensor GND input
Yellow-sensor signal output
Power supply two core wire:
Red-positive pole (ACC)
Black-negative pole (grounding)

Sensors MUST be placed in a dry area to prevent water ingress, where possible mount the sensors upright or at a 45 degree angle to reduce further risk (see images above).
Water ingress will cause the sensors to become faulty. Water damage to the sensors will not be covered under warranty.