Push Switch GARAGE OPENER T1B86BM fits Toyota Prado 150s, Hiace, RAV4, LandCruiser 70s 300s, Camry, Corolla with dual LED in blue MOMENTARY

The following link shows how the garage door switches are wired in vehicles Garage Door Remote Mod

We also have our own specially designed Garage Door Opener Kits with this switch included in stock. If you are interested, please make purchases from this link

Direct OEM Replacement MOMENTARY Push Switch
With Dual LED lights in BLUE

This 12 volt push switch from AOB is a single throw MOMENTARY switch designed to operate your 12 volt accessories. It has a face surface size of 22 mm x 22 mm and uses the original mounting hole of the vehicle.

This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

• Single Pole Single Throw MOMENTARY PUSH switch
• Black hard surface
• Laser etched Legend
• Single upper L.E.D light in BLUE
• Single lower L.E.D light in BLUE
• Upper light is ON when the switch is pressed IN
• Lower light can be wired to separate dash light circuit
• Rated at 3Amp 12V
• Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.

AOBSWT100 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

AOBSWT100 series Illumination

When switch is turned on the top light illuminates.

The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the LED LIGHT BAR logo)