Pressure gauge 220S 160psi twin air bag control Panel

Dual Air Bag Control Panel and One 12 Volt Compressor Switch

This panel is fitted with one of GENUINE VIAIR Illuminated Twin needle gauge sets along with 2 AOB Air control paddle switches and one 20 amp compressor on/off switch. This clever unit lets you control, with out the use of 12 volt solenoids, any of the following combinations of your air bags.

• Both rear off one switch and Both front off the other.
• Both left off one switch and both right off the other.
• Left rear off one switch and Right rear off the other.
• Left front off one switch and right front off the other.

This gauge and switch set comes completely assembled for easy installation using the best quality PU air fittings available. Inlet and outlet is by 1/4'' PU hose.

The 2 air paddle switches allows air to flow to your airbags by pushing the switch down and allows air to escape to atmosphere from the air bags by pushing the switch up.The maximum pressure of the air paddle switch is 110 psi.

The panel face measures 182mm wide 79mm high and 85mm deep.

With a 160 psi max working pressure it is sure to survive the most rigorous out back travel.

The 12 volt 20 amp on/off rocker switch can be used to operate your compressor relay. Warning ensure that a suitable relay of sufficient amperage is used on your compressor start circuit.

The position of your air switches and rocker switch can be moved to suit your needs. They all use the same size cut out hole size.

(Air compressor is needed to operate this switch set, not included)