Push Switch CURVED LIGHT BAR A3C16CC Chrome fits Amarok Volkswagen 2016 ~ 2023 Top dash (ALL MODELS) Center
$46.00
12V 3A Amarok On-Off Push Switch
- With CHROME STRIP
- For VW Amarok 2016 ~ 2023 top dash (All Models)
- For CENTER ONLY
Availability:
In stock
SKU
SWA3C16CC
NEW OEM Replacement Switch
with chrome strip FOR CENTER
Suits : VW Amarok 2016 ~ 2023top dash only
- Match factory colour RED dash lights
- Turns AMBER when activated
- Same as factory switches
Please check the following before making your purchase
- Switch location do you require: LEFT, CENTER or RIGHT side switches
- With Chrome strip or without
- ONLY FITS Amarok 2016 ~ 2023 Models
This high quality 12V 3A push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 30 mm x 24 mm and length of 52 mm and uses the original mounting hole of the vehicle.
This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is an electronic switch rated at 3amp's
Therefore in ALL cases the accessory MUST be wired through a fused relay.
Amarok Switches
Rear picture showing terminals and wiring harness supplied with switch. Wiring diagram will be supplied with switch purchase.
Amarok Switches Illumination
- With dash lights switched on light illuminates RED matching the factory red illumination
- When switch is activated the light changes from RED to AMBER
- The RED light has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, it's your choice.
- The AMBER light is dependent of switch operation
| Fitted Position | Top Panel (2016~2023) CENTER |
|---|---|
| Operation_Type | ON-OFF |
| Switch Logo | CURVED LIGHT BAR C16 |
| Material | Plastic |
| Electric_ Rating | 12V 3A |
| Lights | Dual backlit LED lights. Upper light is ON when the switch is pressed IN. Lower light can be wired to separate dash light circuit. |
Write Your Own Review