Direct Toyota replacement FRONT PARKING SENSOR 8D05SNG ON-OFF Push Button Switch with dual LED lights in LIGHT GREEN

Push Switch FRONT PARKING SENSOR 8D05SNG Horizontal fits Toyota Hilux, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in light green

Push Switch FRONT PARKING SENSOR 8D05SW Horizontal fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in white

$18.60
12V 3A Laser etched ON-OFF Toyota OEM Replacement Push Switch with dual LED lights in WHITE
Availability:
In stock
SKU
SW8D05SW

12 Volt 3amp ON-OFF HORIZENTAL TOYOTA PUSH Switch
Twin L.E.D Lights

This Switch Suits the following models ONLY:

FJ Cruiser
2007 - 2018
HiAce
2005 - 2013
Hilux KUN26R, GGN15R, GGN25R
2005 - Early 2015
Kluger
2001 - 2007
Landcruiser 76 / 78 / 79 Series
Plastic Dash
Landcruiser 100 Series
1998 - 2007
Prado 120 Series
2003 - 2009
Tundra (Centre console if exists)
2005 - 2006

This Switch will not fit the new Hilux GUN series

Please check the hole size before purchase

 


 

This 12 volt push switch from AOB is a single pole single throw ON-OFF switch designed to operate your 12 volt accessories. It has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.

This switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

  • Single Pole Single Throw ON-OFF PUSH switch
  • Black hard surface
  • Laser etched Legend
  • Single LEFT L.E.D light in WHITE
  • Single RIGHT L.E.D light in WHITE
  • LEFT light is ON when the switch is pressed IN
  • RIGHT light can be wired to separate dash light circuit
  • Rated at 3Amp 12V
  • Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's.Therefore in ALL cases the accessory MUST be wired through a fused relay.

 

Example of Dash Panel from 2010 Toyota with AOBSW800 series Push Button Switches with dual LED LIGHTS in WHITE

Example of Dash Panel with AOBSW800 series Push Switches

Panel shown from 2010 Toyota. This Panel is mounted on the left side of the steering wheel.

Rear picture of AOBSW800 series Toyota Push Button Switch

AOBSW800 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

Light Illumination effect of AOBSW800 series Toyota Push Button Switch with dual LED LIGHTS in WHITE

AOBSW800 series Illumination

When switch is turned on the top light (picture 1) illuminates.

The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the LED LIGHT BAR logo)

More Information
Single / Dual Single Push
Face_Size 39mm x 21mm
Switch Logo FRONT PARKING SENSOR D05
Lights Dual backlit LED lights. Upper light is ON when the switch is pressed IN. Lower light can be wired to separate dash light circuit.
Switch_Layout HORIZONTAL
Electric_ Rating 12V 3A
Operation_Type ON-OFF
Color WHITE WHITE
Material Plastic
Extra Info For Toyota Prado 120, HiAce, Landcruiser 76 78 79 100, Kluger, Hilux, FJ Cruiser, Tundra
Write Your Own Review
You're reviewing:Push Switch FRONT PARKING SENSOR 8D05SW Horizontal fits Toyota Hilux, Kluger, FJ Cruiser, Prado 120, HiAce, Landcruiser etc. dual LED in white
Your Rating