AUTO MANUAL 590R2 Rocker Switch dual LED red ON-OFF-ON

12V 20A / 24V 10A ON-OFF-ON Rocker Switch

This high quality 12V/24V Rocker switch from AOB is a double throw ON-OFF-ON switch designed to operate your accessories. It has a face surface size of 49.5mm x 24.5mm and uses a standard din size mounting hole of 37.5mm x 21.2mm. This is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.

• Double Pole Double Throw ON-OFF-ON switch
• Black hard surface rocker.
• Single upper L.E.D light.
• Single lower L.E.D light.
• Top window and bottom bar in RED.
• Upper light is ON when the switch is pressed UP.
• Lower light is ON when the switch is pressed DOWN.
• Lower light can be wired to separate dash light circuit.
• Waterproof rating of IP66.
• Same size as the ARB switches.
• Rated 12V 20A / 24V 10A
• No rear barriers between terminals.
• Wiring diagram supplied with switch.

All symbols are printed directly onto the switch face using modern high tech inks and printers to ensure long image life. we do not use stickers which will wear off in a very short time.

The switch is rated to 20amp at 12V and 10amp at 24V. However in ALL case we recommend that you wire the accessory through a fused relay.

AOBSW500 series

Rear picture showing terminals. Wiring diagram will be supplied with switch purchase. Independent wiring circuit to connect dash lights

AOBSW500 series Illumination

When switch is turned on the top light (picture 3) illuminates.

The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the Zombie Lights logo)