These Switches Suit the following models ONLY:
Please check the hole size before purchase
These 12 volt push switches from AOB are single throw MOMENTARY switches designed to operate your 12 volt accessories. They have a face surface size of 32.5 mm x 22 mm and uses the original mounting hole of the vehicle.
These Switches are aftermarket switches that lock into your existing panel super easy to install in less than 10 min's.
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switches are electronic switches rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.
Dash Panel with AOBSW900 series Push Switches
Panel shown from 2013 LandCruiser 200 series. This Panel is mounted on the right side of the steering wheel.
AOBSW900 series
Rear picture showing terminals and wiring harness supplied with switch
Wiring diagram will be supplied with switch purchase.
AOBSW900 series Illumination
When switch is turned on the top light (picture 1) illuminates.
The bottom light (bar) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.
(this is a sample image with the LED LIGHT BAR logo)
| Single / Dual | Single Push |
|---|---|
| Face_Size | 32.5mm x 22mm |
| Switch Logo | WINCH IN WINCH OUT 53 |
| Lights | Dual backlit LED lights. Upper light is ON when the switch is pressed IN. Lower light can be wired to separate dash light circuit. |
| Switch_Layout | VERTICAL |
| Electric_ Rating | 12V 3A |
| Operation_Type | Momentary |
| Color | GREEN GREEN |
| Material | Plastic |
| Extra Info | TWIN PACK Switches with one WINCH IN and one WINCH OUT |